Ningbo Sunny Electrical Heating Appliances Co.,Ltd

Telephone:

+86-574-23678117

E-mail:

sana@sunnyheater.com

News Detail
Home > News > Content

Tubular Heater To Achieve Energy - Saving Goals Of Many Ways

Tubular Heater to achieve energy - saving goals of many ways
In the absence of any energy-saving measures, the use of Tubular Heater can not reflect the energy-saving side, in order to achieve energy-saving goals, you can improve the electric heater structure, adjust its parameters, etc., I believe that the effect is changed Obvious.
A large part of the user when using the Tubular Heater, only the electric heater outlet pipe insulation, and the surface of the electric heater itself does not make any insulation treatment. But there is data to prove that in the Tubular Heater surface to increase the insulation layer can reduce a lot of energy consumption.
So to remind the majority of Tubular Heater users, in the equipment pipeline to install insulation layer at the same time, do not forget to install the tube heater itself, insulation layer. This long-term operation, saving energy consumption is very impressive, can reduce the operating costs of equipment.
Generally, the power of the Tubular Heater is determined according to the calculation of the air volume and the temperature. Therefore, it is not advisable to use the excessive air volume and the excessive temperature rise if the air volume and the temperature rise have been satisfied. Otherwise, it will lead directly to the heater The power is too large, increase energy consumption. So, rational design, to determine the appropriate parameters is very critical.
When the need for heated air flow through the Tubular Heater, to produce pressure loss, and the greater the pressure loss, the greater the energy consumption of the fan. Therefore, it should be improved from the structure of the Tubular Heater itself, so that the pressure loss caused by it is reduced as much as possible, thereby contributing to the realization of energy saving.
Tubular Heater is a stainless steel heating equipment, in addition to the excellent performance brought by stainless steel, there are small size, waterproof design reasonable advantage. In addition to the Tubular Heater outside the gallbladder and the liner between the use of insulation design, can avoid the loss of heat in the course of work.
In the design of the Tubular Heater in terms of water flow, make full use of the golden section, to ensure that it can fully reflect the high heating efficiency, no high and low temperature advantages. A series of pressure test after the formal, high standards, strict requirements of the Tubular Heater pressure capacity of the national small pressure vessel standards.
Tubular Heater temperature control system and overheating protection system all use the domestic advanced components, high agility, high efficiency, so that the auxiliary heater in the process of work, you can save energy, to avoid product damage. When installing a Tubular Heater, it is usually installed in parallel to the outlet of the pipeline, to play its function.
Its function is in the low temperature of the cold area as an auxiliary heat source equipment used to prevent the heat pump heating capacity and heating performance coefficient of the problem. As the Tubular Heater does not require any other auxiliary equipment, so it is in the installation, operation, maintenance than the use of small boilers and other equipment compared to a clear advantage.
After the installation of the Tubular Heater can be integrated with the central air conditioning unit, the use can be achieved with the unit linkage control, preheating of circulating water to improve the water temperature, both to ensure that the air conditioning unit start and run the normal, but also improve the air conditioning unit The heating efficiency and heating effect.
And then look at its energy consumption, although the Tubular Heater itself will be a good point, but this can improve the efficiency of the central air conditioning unit heating operation to get some compensation, so the total power consumption is not obvious.